Resetting The Motor Stops On A Sunsetter Awning

Limit how often you open and close the awning as overuse on a hot day could cause the motor to cut out.

Resetting the motor stops on a sunsetter awning. These push buttons will be on top of. If the remote control stops working with the awning it needs to be reset. Unplug or stop using the awning and wait a few minutes. When the motor stops press and holdthe programming button on the back of the remote transmitter see fig.

A jog is a short back and forth movement of the motor. Motor to lose stop position settings which will require resetting the motor stop positions. A for 5 seconds until the motor jogs then release. Resetting the limit push buttons of the sunsetter motor awnings with motors installed on the right as you face the house appendix b 2.

If you need to reset the motor stop position settings refer to the enclosed instructions on how to reset the motor stops. The reset process appears convoluted but when followed closely it will reconnect the remote control with the motor control unit. Test the awning for proper operation. From a stepladder locate the limit push buttons on the motor.

Unplug the power cord from the electrical outlet on the wall. The motor could be overheating. Remove four 4 2 phillips screws. Press the neutral stop button on the remote.

A very specific problem but maybe i m not the only one.